Flashing Realme 10 (RMX3630) using SP Flash Tool
Requirements:
- Scatter Firmware for Realme 10 RMX3630
- DFT Tool or Pandora Tool
- SP Flash Tool
- USB Drivers for MediaTek devices
- USB Cable
- Windows PC
Steps to Flash Realme 10 (RMX3630)
1. Install USB Drivers
Install MediaTek VCOM drivers on your PC to ensure your Realme device is recognized by the flashing tool.
2. Download Firmware
Get the scatter firmware for your Realme 10 RMX3630. This firmware is essential for the flashing process.
3. Install DFT/Pandora Tool
Download and install DFT Tool or Pandora Tool on your PC. Open the tool once installed.
4. Load Scatter File
In the tool, load the scatter file (usually named MT6768_Android_scatter.txt) from the firmware you downloaded.
5. Power off the Device
Turn off your Realme 10 before proceeding to the next step.
6. Connect to PC
Hold the Volume Down button on your Realme 10 and connect the phone to your PC to enter Download Mode.
7. Start Flashing
Click on the Download or Upgrade button in the flashing tool to begin the flashing process.
8. Wait for Completion
Once the flashing process is complete, the tool will display a success message. Disconnect the phone from the PC and reboot it.
Important Warning!
If flashing fails, do not panic. Check your connections, USB drivers, and ensure the correct firmware is being used. Try different USB cables or ports if needed.