🛠 Infinix Hot 50 X6882B Anti-Crack Fix (After Wrong Flashing)
Did your Infinix Hot 50 (X6882B) end up stuck in Anti-Crack mode after flashing the wrong firmware? This guide will help you bypass the secure boot lock and bring your device back to life with the correct firmware and preloader setup.
❗ Symptoms of Anti-Crack / Bad Flashing:
- Device stuck on boot logo or shows "Anti-Crack" error
- SP Flash Tool flashing fails with authentication error
- Secure Boot DA error or stuck in BROM mode
- Display or touch not working after flashing
📦 What You’ll Need:
- ✅ Correct Signed Preloader for X6882B
- ✅ Full Factory Firmware (Scatter + DA)
- ✅ SP Flash Tool v5.2208 or higher
- ✅ MTK USB Drivers (VCOM/CDC)
🛠 Flashing Instructions (SP Flash Tool):
- Extract the firmware package using WinRAR/7-Zip.
- Open
flash_tool.exeand load the correct scatter file. - Make sure
Download Onlyis selected (not Format All). - Tick
preloaderonly if your device is completely dead. - Click “Download” and connect the phone in BROM mode (hold Volume Down while inserting USB).
- Wait until the green success tick appears, then reboot the device.
If your device remains locked or doesn’t boot, you may need a Secure DA/Auth Bypass tool such as CM2, Pandora, or UMT MTK.
Still stuck? Drop a comment or request a remote TeamViewer session for full recovery assistance.
