Unbrick OnePlus 7T Pro Europe 10.0.5 (Dead Boot Repair)
If your OnePlus 7T Pro is dead or stuck after a failed flash or update, use this step-by-step method to recover it using Qualcomm Emergency Download Mode (EDL) and the MSM Download Tool.
📦 What You’ll Need:
- A PC running Windows
- Qualcomm QDLoader HS-USB Drivers
- OnePlus 7T Pro Europe 10.0.5 EDL Firmware
- MSM Download Tool
- USB Cable
🛠 Step-by-Step Instructions
- Install Qualcomm USB Drivers
- Download & install QDLoader HS-USB drivers.
- Reboot your PC.
Tip: Disable driver signature enforcement on Windows 10/11 if needed. - Download and Extract the Firmware
- Download the firmware ZIP.
- Extract using 7-Zip or WinRAR.
- Inside you’ll find:- MSMDownloadTool.exe
- EDL Firmware folder
- All flashing files
- Boot into EDL Mode (Emergency Download Mode)
Method 1: Hold Volume Up + Volume Down and connect USB.
Method 2 (Advanced): Open back panel and short test points, then connect USB.
In Device Manager, you should see: Qualcomm HS-USB QDLoader 9008. - Flash with MSM Download Tool
- Run MSMDownloadTool.exe as Admin.
- Select target variant (Europe).
- Click Start to flash.
- Wait for the process to finish without interruption. - Boot Up and Initial Setup
- After flashing, the phone reboots automatically.
- Disconnect from PC.
- Complete setup on OxygenOS 10.0.5.
🎉 You're done! ✅
💡 Notes:
- This guide is for OnePlus 7T Pro (Europe variant) only.
- Use exact firmware version 10.0.5 to avoid issues.
- Do not unplug USB during the flashing process.
- Flashing via EDL is risky – proceed carefully and at your own responsibility.
